Firmware for CPR32-SE Access Network Controller
Copyright Roger Sp.j.
========================================================================

CPR v.2.06.5028  14.2.2011
------------------------------
1. The opertion od remote command "Clear alarms" from the on-line monitoring corrected. Currently, this command clears not only alarm on CPR unit but on all controllers within network as well.

2. New command in PR Master. This new command enables remote control of Alarm Zone state from the PR Master program. 

3. The logic which controls the Alarm Zones improved.

CPR v2.05.5025	24.05.2010
------------------------------
1. Critical error fixed: erroneous input states reported by CPR module 


CPR v2.05.5024	10.04.2010
------------------------------
1. Firmware adopted for CPR32-SE v1 PCB module (with P89C61 microcontroller). 

CPR v2.05.5010	1.02.2010
------------------------------
1. Improved communication between managing computer and CPR unit. Correction is intended to fix problem with so called "synchronization error" which was observed on systems managed via UT-4 interface (LAN/WAN).
